Glue for PVC and PU inflatables 250 cc

Polyurethane inflator glue. Bonding of elastomeric and plastomeric PVC inflatable boat fabrics.

Instructions for use :

The substrate must be clean, dry and degreased with MEK (PVC in contact with MEK becomes tacky). Allow to dry.

This adhesive is used with catalyst, at a rate of 4% (or 40 ml per litre). Mix 4% catalyst with the desired amount of adhesive. Stir to obtain a uniform mixture. Go over the two surfaces to be glued with a brush, applying a uniform film. Allow to dry for 5 to 10 minutes. When the glue begins to set, apply a second coat of glue. Allow to dry for 10 minutes, then join the two substrates and press firmly. Bonding will be instantaneous. Full effectiveness is achieved after 48 hours. This process is ideally carried out at a temperature of 20°C and relative humidity of less than 65%.